The Best Way to glue wallpaper in the corners: instructions, gluing outer, inner Part, docking

Step by step instructions to gluing inner corners

When finishing, the principal problem can be irregular walls as well as the resulting folds on the background. It’s also required to take into consideration that if the walls are crooked, the joints of wallpaper canvases might invisibly.

After gluing the previous one in the front of the inner corner of the fabric must measure the remaining space. It is measured from the edge of the glued cloth to the adjacent wall, and the resulting amount is inserted 10-15 millimeters. When the walls are very curved, the additional figure may be .

Cut a strip equal to the resultant figure, taking into account the allowance. The surfaces are treated with adhesive. Based on the kind of coating it may be just the wall or the surfaces.

The strip has been glued independently using the cut side into the wall. The background should go on the other plane.

In case the glued background is wrinkled, you need to make a few smallish cuts perpendicular to the folds.

Level or incline on the adjacent wall is a vertical lineup. The distance from the corner is equal to the width of the last cut strip, never adding developments.

The surfaces are smeared with glue, and then the coating is glued to the wall with the flat side to the line. The cut side goes onto the adjacent wall.

Protruding corner ought to be pasted by analogy with the interior, but there are small differences, which also have to be taken into consideration when working.

Measured the distance remaining out of the glued background into the adjoining wall. Insert 20-25 millimeters to the figure.

A segment is cut away, considering the additional 20-25 millimeters.

Prior to gluing, the surfaces have been treated with glue.

The edge has to be glued into the wallpaper fixed onto the walls, your own cut « extends » into the adjoining plane. If necessary, small cuts are created in the place of visiting another wallpaper, smoothed and pressed into the wall.

Draw a vertical strip onto the adjacent wall at a distance of only glued cut strip and 6-10 millimeters.

After applying the adhesive, the strip is put on the wall using its flat side towards the line, moving over the border of the already glued strip.

The joints are smeared with adhesive and ironed using a rollercoaster. After that, the upper layer is cut along the ruler and the two layers are combined together.

{ 0 comments… add one }

Leave a Comment